This AC contains minimum performance specifications for systems and equipment airports use to provide a warning to drivers on an airfield about a potential runway incursion. This AC discusses two types of detection systems: a preconfigured, commercial off the shelf (COTS) system; and a system with custom hardware and software.

Contains the Federal Aviation Administration’s (FAA) standards and recommendations for the geometric layout and engineering design of runways, taxiways, aprons, and other facilities at civil airports.This substantial revision fully incorporates all previous changes to AC 150/5300-13 as well as new standards and technical requirements.

See also Interim Guidance on Land Uses Within a Runway Protection Zone.

Contains standards for the planning, design, installation, and maintenance of Engineered Materials Arresting Systems (EMAS) in runway safety areas (RSAs).

Contains the FAA's performance standards, specifications, and recommendations for the design, manufacture, testing and maintenance of equipment used in the boarding of airline passengers. The physical area covered in this AC is that which is bounded by the door of the passenger terminal area, on one end, to the door of the aircraft, on the other end. Although this AC refers only to aircraft boarding (enplaning), all references apply equally to disembarking (deplaning) with the described procedures occurring in reverse order.

The previous version of this AC discussed only the passenger lift scenario and associated equipment. This document updates that effort and addresses the other methods and equipment used to board an aircraft, including passenger boarding bridges, ramps, lifts, and aircraft boarding chairs.

Describes the qualifications for wildlife biologists who conduct Wildlife Hazard Assessments (WHA) for airports certificated under 14 CFR Part 139 and at non-certificated airports funded by the Airport Improvement Program (AIP) or Passenger Facility Charge (PFC) Program. Addresses the minimum wildlife hazard management curriculum for the initial and recurrent training of airport personnel who implement an FAA-approved Wildlife Hazard Management Plan (WHMP).

See also--

• Part 139 CertAlerts
• Wildlife Strike Database and Hazard Mitigation

Provides guidance on the development, installation, testing, approval, and maintenance of Automatic Dependent Surveillance – Broadcast (ADS-B) Out squitter units for airport ground vehicles. Using this AC, airports will be able to acquire approved and authorized airport ground vehicle ADS-B squitter units that are compliant with Title 14 Code of Federal Regulations (CFR), Part 91, Automatic Dependent Surveillance-Broadcast (ADS–B) Out Performance Requirements to Support Air Traffic Control (ATC) Service, as well as the initial set of ADS-B applications. Please note that the technical specifications for manufacturing ADS-B squitter units for airport ground vehicles are published in the FAA’s document, Vehicle Automatic Dependent Surveillance - Broadcast (ADS-B) Specification, Version 2.4, published May 1, 2012.

Contact the appropriate FAA Airport District Office or Regional Airports Division to discuss Airport Improvement Program (AIP) eligibility.

Learn more about Automatic Dependent Surveillance-Broadcast (ADS-B).

Provides guidance on the use of remote sensing technologies in the collection of data describing the physical infrastructure of an airport. This version is a substantial rewrite and includes new sections on remote sensing technologies other than aerial imagery (primarily LIDAR) for collecting airport data. See also the Airports GIS website.

Provides guidelines for operational safety on airports during construction. Principal changes include prohibiting construction in safety areas when associated runway or taxiway is open, providing guidance for incorporating safety risk management, and including checklists for writing Construction Safety and Phasing Plans (CSPP) and for daily inspections.

Provides an interactive specification that airports can use in procuring Aircraft Rescue and Fire Fighting (ARFF) vehicles. It describes the selection process, vehicle requirements, and how to produce formal specifications.

Provides guidance on the use of avian radar systems to supplement an airport’s Wildlife Hazard Management Plan (WHMP) and reduce the potential avian threats to aircraft.

See also:

• Airport Improvement Program (AIP) Guidance Letter 12-04: Avian Radars (3/5/2012) Discusses the eligibility of Avian Radar Systems and the justification required to use AIP grant funds to acquire and install them.
• Notice to Manufacturers of Airport Avian Radar Systems about AIP Buy American Requirement (10/28/2011). The FAA is requesting information to determine if waivers to this requirement are needed.

Provides FAA standards and recommendations for the training of airport firefighting and rescue personnel in the proper operation and tactical use of Aircraft Rescue and Fire Fighting (ARFF) vehicles and ARFF vehicles equipped with High Reach Extendable Turret (HRETs). This guidance includes the development of department Standard Operating Guidelines (SOGs) and the development of department proficiency evaluation standards.

Provides guidance for developing and managing an airport foreign object debris (FOD) program.  In addition, this AC provides specifications for the equipment used in FOD removal operations.

The described program addresses prevention, detection, removal, and evaluation as well as strategies and practices that can help reduce FOD at airports. The guidelines presented in this AC are advisory and can be implemented at the discretion of the airport operator in accordance with the airport operator’s approved Airport Certification Manual.

This AC cancels AC 150/5380-5B, Debris Hazards at Civil Airports, dated July 5, 1996.

Provides guidance on the design, construction, and operation of aircraft rescue and fire fighting (ARFF) training facilities.

Provides guidance to assist airport operators in preparing for water rescue operations.

Provides guidelines on providing airport data to the FAA  using FAA Forms 5010-3 and 5010-5.

See also Form 5010-3 and Form 5010-5.

Contains the FAA standards for markings used on airport runways, taxiways, and aprons. This AC cancels the Signs and Marking Supplement (SAMS).

Because of the size of this document, it is available as one large file (see Complete) or as several smaller files (see Parts 1-4). This document is consolidated to include Change 1, dated November 17, 2010.

Contains standards for the siting and installation of signs on airport runways and taxiways, including taxiway ending markers, location signs, runway distance remaining signs, mandatory hold signs associated with POFZ and CAT II/III operations, and many others.

Explains how to obtain the latest airport-related research and development (R&D) products funded by the Federal Aviation Administration’s (FAA’s) Airports Organization. This AC describes R&D products from the FAA’s Airport Technology Research and Development Branch, the Airport Cooperative Research Program (ACRP), the Innovative Pavement Research Foundation (IPRF), and the Airfield Asphalt Pavement Technology Program (AAPTP).

Provides guidance, specifications, and standards for painting, marking, and lighting of ground vehicles operating in the airport air operations area (AOA). The approved lights, colors, and markings described in the AC assure the conspicuity of vehicles operating in the AOA from both the ground and the air. The AC contains new specifications and recommendations for the painting, marking, and lighting of Towbarless Tow Vehicles (TLTVs).

Furnishes general guidance for airport employees, airport management, and other personnel responsible for aircraft rescue and firefighting (ARFF) operations at the scene of an aircraft accident on the proper preservation of evidence.  It explains the need for preservation of evidence and details operational actions which may be permitted if performed in the interest of preserving life.

Provides information on courses and reference materials for training of Aircraft Rescue and Firefighting (ARFF) personnel.

Provides guidance to the airport operator in the development and implementation of an Airport Emergency Plan (AEP). The AEP addresses essential emergency related and deliberate actions planned to ensure the safety of and emergency services for the airport populace and the community in which the airport is located.

Consolidated file includes Change 2 dated 11/3/2010. Change 2 updates the date by which AEPs must be submitted to June 30, 2011.

Provides the specifications for the collection of airport data for the FAA Airport Surveying – Geographic Information System (GIS) Program. Also explains how to submit data to the FAA, which will forward the safety critical data to the National Geodetic Survey (NGS) for independent verification and validation. The standards covered in this document provide critical information for the operation and safety of the National Airspace System (NAS) and are classified as critical by the International Civil Aviation Organization (ICAO). ICAO Annex 15 defines data as critical when “there is a high probability when using corrupted critical data that the continued safe flight and landing of an aircraft would be severely at risk with the potential for catastrophe.” The information furnished under these standards covers the entire spectrum of the FAA’s airport data requirements. See also FAA Airport Surveying - GIS Program and Airports GIS Video Training Series.

This advisory circular (AC) provides guidance to assist airport operators in developing a snow and ice control plan, conducting and reporting runway friction surveys, and establishing snow removal and control procedures. Version B of this AC cancelled AC 150/5220-13B, Runway Surface Condition Sensor Specification Guide, dated March 27, 1991. Consolidated file contains Change 1.

See also Notice to Manufacturers of Airport In-Pavement Stationary Runway Weather Information Systems about AIP Buy American Requirement (10/28/2011). The FAA is requesting information to determine if waivers to this requirement are needed.