Working in Paterson

Working in Paterson

Results 1-11 of 11 for buncher  

Page 1 of 1

Display:   List   Gallery  
Item Titles
1.Bob Dale rewires a refurbished Watson buncher on the workshop floor at Watson.
2.Bob Dale rewires a refurbished Watson buncher on the workshop floor at Watson.
3.Clifton Eadie preparing motor mounts for a horizontal pay-off machine; these machines pay out wire or cable at a synchronized rate so that the individual wires can then be twisted and combined using a take-up machine like a buncher or a strander.
4.Jimmy Dowling holding the blueprint for a buncher part; the original machine was drawn and built in 1945, but Jimmy makes copies of parts that are used to repair Watson machines still in use that require the part to continue running.
5.A Kinrei buncher disassembled for maintenance on the machine shop floor.
6.Machinist Bob Kuehn working on a Kinrei buncher.
7.Machinist Bob Kuehn working on a Kinrei buncher.
8.Manuel Cintron and Bob Dale completing the rewiring of a Watson buncher on the shop floor.
9.Manuel Cintron repairing the yoke on a Watson buncher.
10.Manuel Cintron repairing the yoke on a Watson buncher.
11.Shafts, drives and pulleys for a Watson buncher being prepared for shipping after being fabricated by Watson machinists.
Display:   List   Gallery